2005 Altima SE-R

Started with Blox Intake, Kinetix Intake Manifold, Full Headers back exhaust system, Uprev Tune, and EGR delete. A dyno run was done before the build and it put down a respectable 264 WHP. Shift Tech was hired to build the engine. It was a hell of a ride, but after overcoming some unique issues, we successfully generated 312 WHP!

48+ WHP GAIN

Altima SER

Dropping off the SE-R to have the engine built

vq35de coming out of the Alitma

Laying Out the Eagle Rods

Checking Rod Bore

Weighing the Eagle rods for consistency

Eagle Rods and Wiseco Pistons assembled

Pistons and Rods Installed in the block

Short block finally complete

Taking a break from the fun stuff to dress up the oil pan

MLS Gasket with copper gasket spray

Time to play dress up for real!

Dressed up VQ35de 1

Dressed up VQ35de 2

Dressed up VQ35de 3

Dressed up VQ35de 4

Dressed up VQ35de 6

Dressed up VQ35de 5

Dressed up VQ35de 7

Built VQ35DE back in the car, no clip

Altima SER made whole again

Altima SER on the Dyno

Dyno Results. Before and After For the Altima SER

Eagle Rods

Wiseco 11-1 Pistons

ACL Bearings

JWT S2 Cams

1mm Oversized titanium Ferrea valves w/supporting springs and retainers

PnP on intake and exhaust ports

ARP head studs

Rev-Up oil pump